CN
Introduction
The S in Molybdenum Disulfide Technical Grade has strong adhesion to the metal, so that Molybdenum Disulfide Technical Grade can well adhere to the metal surface and always play a lubricating function, especially Molybdenum Disulfide Technical Grade still has a low friction factor under high temperature and high vacuum conditions.
Molybdenum Disulfide Technical Grade is a good solid lubricant that can be lubricated in a vacuum or air environment for a long time. The friction coefficient is relatively low, and Molybdenum Disulfide Technical Grade can be lubricated for a long time in the air below 350 ℃.
With more than ten years of research and development experience, it can provide an annual output of 550 tons ofMolybdenum Disulfide Technical Gradeas a patented technology product.
Molybdenum Disulfide Technical Grade is a lubricant grade of molybdenum disulfide (MoS2). Typical MoS2 content (calculated average) is 98.5%.
Chemical Specifications of Molybdenum Disulfide Technical Grade：
|
Maximum % by wt |
|
|
Acid Insoluble |
0.50 |
|
Iron |
0.25 |
|
Molybdenum Trioxide |
0.10 |
|
Water |
0.20 |
|
Oil |
0.05 |
|
Carbon |
0.50 |
|
Acid Number |
0.05 |
*Acid number is determined at time of production. Prolonged storage will result in slight oxidation,which will produce an increase in acid number.The smaller particle size grades are more susceptible to surface oxidation.Acid number is expressed as an absolute value and is the mg of KOH required to neutralize the acid in a one-gram sample.
Particle Size Specifications of Molybdenum Disulfide Technical Grade By Microtrac：
|
Grade |
D50 |
D99(Maximum) |
|
Technical |
16.0-30.0μm |
180μm |
Typical Particle Size of Molybdenum Disulfide Technical Grade By Microtrac By Fisher Sub-sizer and Bulk Density:
|
Grade |
Fisher Number, μm |
Bulk Density(Scott) |
|
Technical |
3 to 4 |
1.3g/cm3 |
Packaging of Molybdenum Disulfide Technical Grade：
|
Grade |
Packaging Fiber Drum |
Pallet weight |
|
Technical |
25kg |
450kg |
|
18 drums/pallet |
||
Figure 1: Applications of Molybdenum Disulfide Technical Grade
Molybdenum Disulfide Technical Grade is widely used in Lubricant, Plastic modification, Grease, and powder metallurgy such as Valve guide.
Figure 2: Packaging of Molybdenum Disulfide Technical Grade.
Packed in 25kg wooden barrels or 50kg iron barrels.
Figure 3: PTFE sealing ring with added Molybdenum Disulfide Technical Grade
Figure 4: Molybdenum Disulfide Technical Grade are loaded and ready to be shipped to the port.
Molybdenum Disulfide Technical Grade
2024-03-28 10:10:25
Molybdenum Disulfide Technical GradeIntroductionThe S in Molybdenum Disulfide Technical Grade has strong adhesion to...
share
